Automate

 View Only

  • 1.  ME51N - PR number is missing from Run Log

    Posted 07-12-2019 17:43
    <main role="main">

    • I have recorded a purchase requisition (PR) using ME51N. The script runs and successfully creates the PR. However the message displayed in the Run Log, is missing the number for the PR that was created. I have tried re-recording the transaction in all modes (BATCH, Standard, with SAP controls, without SAP controls etc.) in all the variations I have the same issue.  If I enter the transaction manually in SAP, I get the correct (full) message. Have you seen this? I have ran out of ideas.

    </main>

    ------------------------------
    Francis Escamilla | Developer
    Exxon Mobil Corporation | 832-624-2240
    ------------------------------


  • 2.  RE: ME51N - PR number is missing from Run Log

    Posted 07-15-2019 03:06
    ​Hi Francis,

    Have you tried turning on Extended logging?  Normally logging only returns the last message I believe, extended returns them all.

    ------------------------------
    Mark Tiller | Delivery Enhancement Developer
    Transport for London (TfL) | 0203 054 4196
    ------------------------------

    Original Message


  • 3.  RE: ME51N - PR number is missing from Run Log

    Posted 07-23-2019 17:12
    I noticed that changing the script mode from BATCH to Non-Bath does indeed return the PR number. However, the views/pages look differently. I need to record in Non-Batch mode. However, Winshuttle Studio keeps changing the recording mode automatically to Batch even when I tell it to record in Standard (non-batch) mode. I am waiting on SAP contacts to make some changes to a table to see if it helps.

    ------------------------------
    Francis Escamilla | Developer
    Exxon Mobil Corporation | 832-624-2240
    ------------------------------

    Original Message


  • 4.  RE: ME51N - PR number is missing from Run Log

    Posted 07-24-2019 04:14
    Hi Francis,

    in my experience, when I change the recording mode before filling the transaction code, it automatically changes back when you do. Try to input the transaction code first and then change the recording mode. 

    I hope that helps.

    Regards,

    Andre

    ------------------------------
    Andre Monteiro | Senior Systems Administrator
    UK Power Networks
    ------------------------------

    Original Message