Thank you Sigrid. That confirms my research too.
Basis is reluctant change of user type, because then it will have password change policy enforced and also have limitation on parallel sessions, that may become even bigger problem.
I will be requesting to create custom BAPI for that.
------------------------------
Alexey Skotnikov
Sr Technology Manager
ABBOTT RAPID DX INTERNATIONAL LIMITED
------------------------------
Original Message:
Sent: 12-01-2023 18:01
From: Sigrid Kok
Subject: UKM_BP, Start SAP GUI and System User
Hi Alexey
Tried a few variations and ran into the same thing as you, as BP is much like an "SAP Enjoy transaction" and needs the launch gui checked.
Is there any way the system account can be modified?
If not, perhaps you can ask your Basis team for a BAPI. I did a search and struck out on finding one that works with the Credit data.
Best Regards,
Sigrid
------------------------------
Sigrid Kok
Precisely Software Inc.
Original Message:
Sent: 11-30-2023 13:24
From: Alexey Skotnikov
Subject: UKM_BP, Start SAP GUI and System User
Dear Community!
We have a script that use transaction UKM_BP to set credit segment data. It works fine as recording, but only if "Start SAP GUI" checkbox is set. If you unset checkbox, we get message "No batch input data for dynpro (SAPMSSY0 0120)" and unable to debug (because in debug it works fine).
The problem is that we have to use system account that is set up as User Type = "B System", and doesn't allow interactive logons, so it can't work with this checkbox enabled. Is there a way around this issue?
Thank you!
------------------------------
Alexey Skotnikov
Sr Technology Manager
ABBOTT RAPID DX INTERNATIONAL LIMITED
------------------------------