Automate

I'm trying to record a script for F-92, I enter the first line item, and hit enter to get to the next line item.  Our configuration throws a warning about a credit check, if I press enter again, it moves me on to the next line item and I can finish recording the script. 

When I look at the resulting script in Expert mode, I don't see the extra steps around the warning and the extra enter command I used. I tried to copy the block of code for the customer line item and just add a /00 in the OK Code for the enter and that doesn't seem to work. 

When I debug the script, it gets to the warning and then the normal little box for the OK code disappears and isn't visible any longer. 

Anyone experienced anything similar?

Josh

------------------------------
Josh Bawden
J.R. Simplot Company
ID
------------------------------

Hi Josh

Am not entirely sure what you're trying to accomplish.  Is it that the script isn't running when you test it?

For capturing the messages, have you tried to enable Extended Logging?  It's on the Expert mode tab.  

For the script itself, if it's a warning and you hit an extra enter, it isn't always captured because that's an extra step in the interface the script won't need.  But if there is a pop-up or error, you will see the extra entries.

Best Regards,

Sigrid

------------------------------
Sigrid Kok
Precisely Software Inc.
------------------------------

It's a warning message that shows up in the bottom with a Yellow warning sign.  It gets stuck when I try and debug the transaction, I get to the point below, where the warning message shows up but I can't get any farther when debugging. The little box asking for an ok code is not there. 

------------------------------
Josh Bawden
Information Management Engineer
J.R. Simplot Company
ID
------------------------------

Original Message:
Sent: 12-13-2023 10:08
From: Sigrid Kok
Subject: Problems capturing Warning message with F-92 Asset Sale to Customer

Hi Josh

Am not entirely sure what you're trying to accomplish.  Is it that the script isn't running when you test it?

For capturing the messages, have you tried to enable Extended Logging?  It's on the Expert mode tab.  

For the script itself, if it's a warning and you hit an extra enter, it isn't always captured because that's an extra step in the interface the script won't need.  But if there is a pop-up or error, you will see the extra entries.

Best Regards,

Sigrid

------------------------------
Sigrid Kok
Precisely Software Inc.
------------------------------