Data360 Analyze

Hi, I'm not too sure why this is happening.

I have a modify fields node that just fails to run. Usually, I get information in the Errors panel on the left but here all I get is the red text and the status of the node is set to failed. All that the modify fields node does is remove unneeded columns so I'm not sure why it's failing.

Can anyone assist? 

------------------------------
Joshua Wall
Knowledge Community Shared Account
------------------------------

I had this happen to me... it was a character in the field name that was the issue. Not sure if that helps

------------------------------
Geoff Geoff
Windstream Communications
Little Rock AR
------------------------------

I've seen this happen too.  The node was unable to save an error message, and may not have even tried.

What @Geoff Goldsmith described is it failing during setup, and it died because a field had a bad character, maybe a colon character, in a field name.

------------------------------
Ernest Jones
Precisely Software Inc.
PEARL RIVER NY
------------------------------

@Geoff Goldsmith and @Ernest Jones 

Thanks for your replies guys. Much appreciated!

Turns out that the reason for the error was that the server has run out of disk space. Strange that it didn't give us an error though. I've seen errors regarding disk space before. Maybe there was just so little space it couldn't even log a new error?

------------------------------
Joshua Wall
Knowledge Community Shared Account
------------------------------

Original Message:
Sent: 04-19-2023 13:19
From: Ernest Jones
Subject: Nodes Fail without providing additional information

I've seen this happen too.  The node was unable to save an error message, and may not have even tried.

What @Geoff Goldsmith described is it failing during setup, and it died because a field had a bad character, maybe a colon character, in a field name.

------------------------------
Ernest Jones
Precisely Software Inc.
PEARL RIVER NY
------------------------------