Hi
From the
Tools window, you should be able to find the tool on the
Registered tab. At least that's the case if you have downloaded and installed the tool from the
MapInfo Marketplace from inside MapInfo Pro.
Now check the
Autoload option next to the tool. This will automatically load the tool when MapInfo Pro starts.
If you can't see the tool on the
Registered tab, try this.
1. Run the tool
2. Go to the
Tools window and locate the tool in the Running tab.
3. Right-click on the tool and select
Register Tool
Note that in the image above, it says
Unregister Tool. That's because I already have it registered.
In the dialog that pops up, you should be able to just click
OK to get the tool registered.
Now, you can check the Autoload option on the
Registered tab.
------------------------------
Peter Horsbøll Møller
Principal Presales Consultant | Distinguished Engineer
Precisely | Trust in Data
------------------------------
Original Message:
Sent: 06-02-2022 12:34
From: Sanketkumar Desai
Subject: Find Points on Map
Thanks a lot, Peter. This tool serves the purpose.
The challenge that I am facing now is - I have to go to the folder where this plug in is saved and double click to populate in to the Map Info. Is there a way to add this plug in as a short cut on Map Info? So I can access it easily.
Thank you.
------------------------------
Sanketkumar Desai
AT&T
SAN RAMON CA
Original Message:
Sent: 05-31-2022 16:36
From: Peter Møller
Subject: Find Points on Map
Check out the tool Mark the Spot in the MapInfo Marketplace.
It takes a lat/long coordinate as input and shows it on the map.
You can access the Marketplace directly from the Home tab within MapInfo Pro.
Or find the tool here: Mark the Spot
------------------------------
Peter Horsbøll Møller
Principal Presales Consultant | Distinguished Engineer
Precisely | Trust in Data
Original Message:
Sent: 05-31-2022 16:24
From: Sanketkumar Desai
Subject: Find Points on Map
How can I find a point with putting in Lat and Long as an input into the MapInfo?
I tried to do ctrl+f, but it did not quite help me with this.
Thank you.
------------------------------
Sanketkumar Desai
AT&T
SAN RAMON CA
------------------------------