Thank you Peter this was helpful.
With those two option being switched on, my polygons shrinked.
Then I noticed on the top, there is an exporting option, because we are actually exporting it, not really printing so I switched on the option for Polygon mode and it worked!
I tested it again with Subdivide Printing and Polygon mode on Printing card, switched off. But it didn't work.
Map comes right only if all of them are on.
Once again, for those who might have the same or the similar issue:
Pro - > Options -> Devices (Output settings) -> Printing -> Subdivide printing ON ->Polygon Mode ON
Pro - > Options -> Devices (Output settings) -> Exporting -> Polygon Mode ON
Once again, thank you all for your help,
Adrijana
------------------------------
Adrijana Grujić
Slough Borough Council
SLOUGH
------------------------------
Original Message:
Sent: 02-04-2021 02:49
From: Peter Horsbøll Møller
Subject: PDF export Issues
Hi
Can you check your Output Preferences found on the Pro tab under Options:
I have highlighted two settings that you can try switching from your current setting.
Also, check out the MapInfo Pro Printing Guide if that holds any clues.
------------------------------
Peter Horsbøll Møller
Principal Presales Consultant | Distinguished Engineer
Precisely | Trust in Data
Original Message:
Sent: 02-04-2021 02:44
From: Adrijana Grujić
Subject: PDF export Issues
I have. It's even worse. I mean, those rectangles are gone and everything else too.
------------------------------
Adrijana Grujić
Slough Borough Council
SLOUGH
Original Message:
Sent: 02-03-2021 13:23
From: Andrei Veselov
Subject: PDF export Issues
Adrijana, have you tried to enable "Postscript Simulation" option?
------------------------------
Andrei Veselov
Pitney Bowes Software Inc.
Troy NY
Original Message:
Sent: 02-03-2021 09:20
From: Adrijana Grujić
Subject: PDF export Issues
I have changed the hatch pattern and it is the same. If I export the map as a JPG, than everything is ok. No additional rectangles. So it's something about PDF file export.
------------------------------
Adrijana Grujić
Slough Borough Council
SLOUGH
Original Message:
Sent: 02-03-2021 08:42
From: Peter Horsbøll Møller
Subject: PDF export Issues
I assume you mean the big rectangle that appears behind the polygon in the PDF document, right?
Do you get the same if you a) use a different hatch pattern in the polygon b)save the layout to for example a JPG image?
------------------------------
Peter Horsbøll Møller
Principal Presales Consultant | Distinguished Engineer
Precisely | Trust in Data
Original Message:
Sent: 02-03-2021 04:19
From: Adrijana Grujić
Subject: PDF export Issues
I have some issue with exporting layout as a pdf.
If you open attached files, you'll find out that what you can see in the picture In MIPro (screenshot from MapInfo) is not what I've got in PDF (In PDF Viewer).
Anybody know the reason?
------------------------------
Adrijana Grujić
Slough Borough Council
SLOUGH
------------------------------