Data360 Govern

 View Only

  • 1.  You cannot enter 1.00 in the Threshold for a DQR in Prod

    Posted 08-11-2020 07:46

    When you create a new DQR, the first item to enter is the Threshold. If that is 100% good quality, then you enter 1.00. BUT as soon as you hit the "1" key the value changes to 0. 

    This problem can be reproduced in PROD, not in DEV. 

     

    Attached files

    Capture.PNG

     



  • 2.  RE: You cannot enter 1.00 in the Threshold for a DQR in Prod

    Employee
    Posted 08-12-2020 07:23

    Note: This was originally posted by an inactive account. Content was preserved by moving under an admin account.

    I'm seeing the same behavior internally, so I'll be raising a support ticket to look into the issue further. In the meantime, you can use the following two methods as workarounds:

    - If you enter 2, 3, 4, etc... it will auto-enter in as 1 instead

    - You can use the arrows on the right side of the input bar to increase the number