Automate

hi team,

i'm trying to extend the materials to the classification view as per attached steps but getting error.
please advise how to get over this error. thanks.

------------------------------
suthagar
------------------------------

Hi Suthagar -

Try changing the Max number of hits to 1. That should only show final_output_torque


Thanks,

------------------------------
Jennifer Hwang | Senior Solutions Engineer
Winshuttle North America
------------------------------

hi Suthagar, I usually create and update u number of materials in one go. For classification I have a MM01 followed by a MM02, so if a material does not exist yet, I create necessary data and if it does, data will be extended. Next to Jennifers remark about the 1 max hit, I also check for first transaction. 
rgds, jan

------------------------------
jan ketele | Sr engineer release mgt
Xeikon Manufacturing NV | +3234431875
------------------------------

Hi Suthagar

Besides the excellent suggestions from my colleagues in this thread, please put an IF around this part of the script with the pop-up for class type and only do it for the first transaction

You will only be prompted once for it.

Note in this screen shot I also used the filter on the pop-up, so that I know for sure which class type I'm choosing:
there's a dropdown to pick first transaction
it ends up looking like this


Again, for the first material, the class type selection will pop-up.  For all subsequent materials, it will not.

Hope that helps,
Sigrid

------------------------------
Sigrid Kok
PSE | Winshuttle NA
------------------------------