LAE

Welcome to the LAE community!  Please feel free to start a discussion in the discussion tab or join in a conversation.

Discussions

Members

Resources

Events

 View Only

  • 1.  Editing Node Parameters Causes BRE Crash

    Employee
    Posted 02-12-2014 11:40

    Note: This was originally posted by an inactive account. Content was preserved by moving under an admin account.

    Originally posted by: Aehetag

    This happens relatively often and it's most often when I open and close the declare parameters menu without making changes.
    This spans all node types.

    I run Enterprise Edition 4.6.1

    When I close the menu, a visual studio error/debug menu pops up and then the BRE client closes.

    Any idea what's causing this? Or what additional info I should provide?

    Thanks.


  • 2.  RE: Editing Node Parameters Causes BRE Crash

    Employee
    Posted 02-12-2014 12:15

    Note: This was originally posted by an inactive account. Content was preserved by moving under an admin account.

    Originally posted by: DanRosenblatt

    Do you receive the error message "<Group.Glyph>.Status not defined error can occur when closing the declare parameters." upon closing the Parameters window?

    This is an issue that we have identified and plan to address in an upcoming release of LAE.


  • 3.  RE: Editing Node Parameters Causes BRE Crash

    Employee
    Posted 02-12-2014 12:31

    Note: This was originally posted by an inactive account. Content was preserved by moving under an admin account.

    Originally posted by: ejones

    I think I've seen what you describe in 4.6.0. What I have figured out is that after you leave change the window where you declare the parameters, you should wait a moment before clicking Ok on the node definition window. If you watch carefully you may see the node edit display window refresh once or twice. After that happens then it is safe to click Ok. I think the main reason that I haven't seen this issue if 4.6.1 is that I've learned to wait.


  • 4.  RE: Editing Node Parameters Causes BRE Crash

    Employee
    Posted 02-12-2014 12:34

    Note: This was originally posted by an inactive account. Content was preserved by moving under an admin account.

    Originally posted by: Aehetag

    I've attached a screenshot of the visual studio message. I do not open it in debug since the computer I'm running isn't very good. I don't any error message from the BRE client, just the visual studio. However, it seems like it may be the same issue since it always happens when I close the parameters menu.

    At least it's not my installation. I'll just patiently wait for the next release.

    Thank you
    Attachments:
    bre-error.jpg


  • 5.  RE: Editing Node Parameters Causes BRE Crash

    Employee
    Posted 02-12-2014 12:40

    Note: This was originally posted by an inactive account. Content was preserved by moving under an admin account.

    Originally posted by: Aehetag

    Originally posted by: ejones
					

    I think I've seen what you describe in 4.6.0.  What I have figured out is that after you leave change the window where you declare the parameters, you should wait a moment before clicking Ok on the node definition window.  If you watch carefully you may see the node edit display window refresh once or twice.  After that happens then it is safe to click Ok.  I think the main reason that I haven't seen this issue if 4.6.1 is that I've learned to wait.
    Thanks! This seems to work. A few extra seconds waiting is better than restarting the client.