I made a change to the script so it uses the buttons available on the maintenance item selection screen. Please try it and let me know if it works.
Precisely Software Inc.
Original Message:
Sent: 11-11-2024 13:59
From: Abhishek Soni
Subject: RAISE EXCEPTION ERROR
Hello,
Thank you for the quick response!
I get the same error with standard mode as well. Based on my assessment, it seems like the script wants to run before SAP screen loads. Works fine if I use IP01 with no Maintenance Items. But if I enter details for Maintenance Items, that's when the scrip runs into this issue.
Abhishek
------------------------------
Abhishek S
Arlington VA
Original Message:
Sent: 11-11-2024 13:51
From: Maria Ebner
Subject: RAISE EXCEPTION ERROR
Hi Abhishek,
When I see that error I change the recording mode. The script is currently set to Standard non-batch with controls, so I recommend changing it to Standard batch. To do this, open the script in Studio, go to the Map tab, go to the Properties panel on the right, find the recording mode and change it:
Please change the mode, save the script, and run it. Let me know if that resolves the issue.
Thanks,
------------------------------
Maria Ebner
Precisely Software Inc.
Original Message:
Sent: 11-10-2024 22:16
From: Abhishek Soni
Subject: RAISE EXCEPTION ERROR
Using IP01 to build new PM with Maintenance Items.
Attached is the script but getting this Raise_Exception error. In Debug mode, the script goes wrong when selecting Maintenance Item.
Any help/ insight would be greatly appreciated! Thank you!
------------------------------
Abhishek Soni
Venture Global LNG
Arlington VA
------------------------------