Spectrum Spatial (SSA/LIM)

Hi, 

Hoping someone might have a solution for me: when searching by property numbers, the neighbouring property details are shown when the location point is close to the boundary. SSA 2022.1

thanks 

Kate 

Hi Kate,

I assume you click on the map and you get also close boundaries through the location search. That happens because when you click into the map SSA creates a circle of 4 pixels around the click and searches within that circle.

This is done as you would not find any point location by clicking in the map if you simply convert the clicked pixel into coordinates. That would be inaccurate to find points.

Regards

Andreas

Hi, 

Hoping someone might have a solution for me: when searching by property numbers, the neighbouring property details are shown when the location point is close to the boundary. SSA 2022.1

thanks 

Kate 

Hi Kate,

in addition to my statement above you can configure that pixel width in the project settings for each layer. See Search Width setting in below picture:

Hi Kate,

I assume you click on the map and you get also close boundaries through the location search. That happens because when you click into the map SSA creates a circle of 4 pixels around the click and searches within that circle.

This is done as you would not find any point location by clicking in the map if you simply convert the clicked pixel into coordinates. That would be inaccurate to find points.

Regards

Andreas

Hi, 

Hoping someone might have a solution for me: when searching by property numbers, the neighbouring property details are shown when the location point is close to the boundary. SSA 2022.1

thanks 

Kate