MapInfo Pro

 View Only

  • 1.  Moving the Map Window embedded scale bar closer to Map Window frame/border

    Posted 27 days ago

    I'm using Map Window insets that are approximately 6cm wide. When I embed a scalebar, it sits in the middle of the page due to Mapinfo Pro blocking it from being near right or left justified. Any solutions that can overwrite this issue e.g. Go to settings etc., would be greatly appreciated. I submitted another identical discussion document earlier, though can't seem to find it and not sure I created within the correct Community. Thank you Jason



    ------------------------------
    Jason Kroeger
    Spatial Products Lead
    DEPARTMENT OF SOCIAL SERVICES
    Canberra BC ACT
    ------------------------------


  • 2.  RE: Moving the Map Window embedded scale bar closer to Map Window frame/border

    Employee
    Posted 27 days ago

    Hi Jason

    I assume you refer to this "border" from the side of the map to the scale bar

    , right?

    It seems strange that you can place the scale bar next to the bottom of the map but need to keep a 1 cm distance to the side of the map.
    Currently, we have no settings that control that distance. The X and Y offset values move the adornment away from the window edge - but only initially. You can move the adornment closer to the edge afterward.
    There is an idea in our Ideas Portal that covers this request: Allow Scalebar to be Positioned with Negative Values. I'd recommend that you give it a vote. Feel free to add a comment too.


    ------------------------------
    Peter Horsbøll Møller
    Principal Presales Consultant | Distinguished Engineer
    Precisely | Trust in Data
    ------------------------------

    Original Message