MapInfo Pro

 View Only

  • 1.  Digitizing structural symbols

    Posted 03-29-2022 17:37
    Could someone point me to where I'd see the pulldown for digitizing the structural symbols into a point table?  I see under Analysis\Display\Structural symbols but this is to update an existing point map to display the symbol.  I am wanting to digitize the symbols to autopopulate the azimuth and the symbol Discover code.  I am in 2019 Discover, Build 45.  I haven't used this tool since upgrading to this version.  The 'old' version was located in the Discover pulldown.  Any comments, greatly appreciated!

    ------------------------------
    Giselle Schween
    Zone 14 GeoInfo Solutions
    Winnipeg MB
    ------------------------------


  • 2.  RE: Digitizing structural symbols

    Employee
    Posted 03-30-2022 05:53
    @Joshua Knight, any suggestions you can offer to help out Giselle?

    Thanks​

    ------------------------------
    Peter Horsbøll Møller
    Principal Presales Consultant | Distinguished Engineer
    Precisely | Trust in Data
    ------------------------------

    Original Message


  • 3.  RE: Digitizing structural symbols

    Posted 03-30-2022 23:16
    Hi Giselle

    In Discover 2019 you can find these under Discover>Data Entry>Table Entry or Record Entry. In the newest version 2021, they have been moved to a new menu tab called Project.

    If you have any other Discover questions you can reach out to support at support.discover@dataminesoftware.com

    ------------------------------
    Joshua Knight
    Datamine Australia Pty Ltd
    Kew VIC
    ------------------------------

    Original Message